At least the command must be without /Hello, I´ve been trying to configure the plugin but I am obviously doing something wrong since I haven´t been able make it work.
Here is what I´ve been doing:
1) Set a block coordinate as the bottom left corner of the portal and build a frame with any blocks from that position along the X axis. ie. 193 4 181
2) Go into the server filess > plugins > portals > config.yml
3) Input values into the code as follows:
# Portal from worldA to worldB
# portal's corner x
# portal's start y
# portal's corner z
# portal's width
# portal's height
# portal's rotation x or z
# portal's command
command: "/mw tp worldB"
4) Restart server
I would very much appreciate any guidance that would help me set up the portals in my server.
Thank you very much.
Read the rest of this update entry...Added option to teleport player to world's default spawn when he uses portal. This can be used to fix infinity portal loop when using server transfers in portals on servers with player data saving enabled. Config file will update automatically.
The setup of the plugin doesn't allow for permissions support the code for grabbing the command is missing a p. .The code should be changed fromAt least the command must be without /
The project wouldn't even compile with that ?The setup of the plugin doesn't allow for permissions support the code for grabbing the command is missing a p. .The code should be changed from
that way the server can pull the perms from the player.
I say just give it a shot if it doesn't work then it doesn't work but i think whats happening is its running command through server but executing as player. But some commands are not working in that fashion like mw tpHowever when i try to use the multiworlds plugin teleport with this it says i dont have perm as op or when i set default group to have permission. I found that solution by looking at the plugin for using signs for commands it had that script. That one supports multipass as well as runs when you have perms